How to automatically turn on the air conditioner? Most often this question arises in several cases:
- after prolonged downtime;
- if the remote control is broken (lost).
We will deal with the situations in which the owners can not independently figure out how to turn on the air conditioner.
How to turn on the air conditioner without remote control
Sometimes the remote disappears somewhere, the batteries run down or the remote is broken. There is always a button to turn on the air conditioner! And it is located on the front of the internal module under the curtains. The air conditioning power button is covered by a small lid made of the same plastic as the body. It must be carefully picked up and lifted.
A manual control panel is detected. The button may be highlighted. If the air conditioner is in good condition, it lights up in red or green. The switch is called operation or on \ off.
Press on it and do not release your finger for a couple of seconds. You will hear a characteristic sound when you turn on the air conditioner. It means that the air conditioner is turning on. If you want to start heating, you need to quickly press the button again.
The air conditioner starts automatically. And you can make changes to it only with the help of the remote control.
How to turn on the air conditioner after a long period of inactivity
There is a certain air conditioning circuit after a long period of inactivity or transportation, you can perform the procedure yourself.
Step-by-step instructions for turning on the air conditioner in the cold after downtime:
- Make sure that the outside temperature is positive;
- Unplug the air conditioner;
- Check if the outdoor unit is dry, the radiator grill is intact;
- Check the condition of the filters in the indoor unit, clean them if necessary;
- Check the condition of the batteries;
- Turn on the power, the sound when you turn on the air conditioner will notify about its start;
- If the air temperature in the room is above 20 degrees, set the “cold” mode to the lowest temperature and the highest speed of rotation of the fan blades;
- When really very cold air comes out of the case, leave it to work for a quarter of an hour, but for now check the operation of the curtain and fan speeds;
- Turn off with the remote control. Now the air conditioner can be used in normal mode.
If after 10 minutes after the air conditioner automatically turns on, it does not go cold, blows weakly or makes noise, call the service department.
The circuit for turning on the air conditioner is very simple, even inexperienced users can handle it. However, if during the test there is the slightest doubt about the operation of the device, immediately turn it off and call the masters.
